Replacement Of Sand By Marble Powder In Concrete

  1. Home
  2.  / Replacement Of Sand By Marble Powder In Concrete
replacement of sand by marble powder in concrete

replacement of sand by marble powder in concrete

Normal concrete Tensile strength of normal concrete 119 International Journal for Modern Trends in Science and Technology Partial Replacement of Cement to Concrete by Marble Dust Powder 4.4.4. Concrete with 15% replacement of 4.5.3.May 18, 2015 Based on the experiment result it showed that replacement of cement and sand by marble powder up to 10% increases the compressive strength but above 10% content of marble powder decreases the compressive strength. Split tensile strength increases with increase in marble powder …

Best Or Partial Replacement Of Sand In Concrete

Best Or Partial Replacement Of Sand In Concrete

replacement of Cement with Waste Marble Powder Partial replacement of cement by varying percentage of marble powder reveals that increased waste marble powder (WMP) ratio result in increased strengths of the mortar and concrete Thus they found out the optimum percentage for replacement of MDP with cement and it is almost 12.5Use of Waste Marble Powder as Partial Replacement in. It can be observed that the flexure strength for the concrete mix containing 10% of marble powder dust in cement got increased by the value of 9.2% and for 10% replacement with sand the flexure strength also got increased about 9.3% but it decreased when the mix contains 20% marble powder dust against cement (10%) and sand(10%) about 10% ...

Synergistic Effect of Marble Powder and Green Sand on the

Synergistic Effect of Marble Powder and Green Sand on the

The durability as well as workability has increased to large extent by use of marble dust as replacement of fine aggregate and coarse aggregate. The effect on properties of concrete were investigated and concluded that optimum percentage for replacement of sand with marble powder in concrete …Partial Replacement of Cement With Marble Powder in Concrete. Marble powder: The marble dust is obtained from RAK ceramics. The specific gravity of tile dust is found to be 2.62 and the fineness is found to be 7.5%. 3.METHODOLOGY: The evaluation of tile powder which is used as a replacement of cement material begins with the concrete testing.

Study on Marble Powder as Partial Replacement of

Study on Marble Powder as Partial Replacement of

fine aggregate replacing natural sand in concrete. The replacement is done partially and fully in the proportion 0%, 25%, 50% and 100% and its effect on concrete properties were analyzed and outcomes that replacement of 50% of sand with marble powder is optimum percentage in concrete. Ronak Malpani et.al (2014) experimentally studied the ...Concrete with the Partial Replacement of Cement by Marble Powder Dust and Sand by Stone Dust Md Mahboob Ali*, Prof. S.M.Hashmi ** *P.G Student of structural Engineering, Department of Civil Engineering, K.B.N College of Engineering, Gulbarga-585104

What are the Materials for Replacement of Sand in Concrete

What are the Materials for Replacement of Sand in Concrete

Feb 04, 2019 The use of marble powder and green sand as fine aggregate replacement created a favorable effect on reducing the porosity of the concrete. The reduction in the water absorption caused a decrease in the voids and is responsible for the improvement in the mechanical strength and impermeability properties of concrete.This paper reports the experimental study undertaken to investigate the influence of partial replacement of sand with limestone waste (LSW), with marble powder (M.P) as an additive on the concrete properties. The replacement proportion of sand with limestone waste, 25%, 50%, and 75% were practiced in the concrete mixes except in the concrete mix.

(PDF) Partial Replacement of Cement to Concrete by Marble

(PDF) Partial Replacement of Cement to Concrete by Marble

Marble powder and Silica sand had been used as replacement of cement and fine aggregate by different percentage for making concrete. The percentage replacement of marble powder will be 0%, 10%, 20% & 30% and silica sand will be 0%, 25%, 50% &75% with M Sand. Key words: Marble powder, Silica sand, M sand, Compressive strength, Split tensile Strengthmaterial which is partial replacement of cement with marble powder and sand with glass powder. In this concrete 10% of glass powder is commonly replaced by sand in optimum level and 0%, 10% & 20% of marble powder replaced with cement respectively. …

Project on Partial Replacement of Cement with Marble Powder

Project on Partial Replacement of Cement with Marble Powder

Shirule et al: studied the ―Partial Replacement of cement with Marble Dust Powder‖. It can be concluded that for M20 grade concrete The Compressive strength of Cubes are increased with addition of waste marble powder up to 10% replace by weight of cement and further any addition of waste marble powder the compressive strength decreases.Marble Powder As A Partial Replacement Of Sand. V. CONCLUSION From the test results it is clearly evident that granite powder as a partial replacement of sand proves to be beneficial when Durability properties of Concrete is considered. Durability of Concrete using Granite Fines is almost same as that of reference mix (GF0), However at 30% ...

Experimental Study on Concrete by Partial Replacement

Experimental Study on Concrete by Partial Replacement

In concrete production, replacing of sand up to 20% by marble waste powder gives similar strength as of concrete mixes with 100% sand both at early and latter ages. Manju Pawar et.al 4 A Study has been conducted on Periodic Research, The Significance of Partial replacement of Cement with3.5 Marble Powder The specific gravity of marble is 2.577. Local available marble powder used as partial replacement of fine aggregate in concrete. 3.6 Granite Powder Granite belongs to igneous rock family. Granite powder obtained from the polishing units and the properties were found.

sand replacement by marble powder

sand replacement by marble powder

The evaluation of Ceramic Waste Powder and Marble Dust Powder for use as a replacement of cement material begins with the concrete testing. The study is conducted to analyze the compressive strength of concrete when the base materials, i.e. Cement is replaced with ceramic waste powder and Marble Dust Powder respectively.When marble powder is partially replaced in cement by weight, there is a marked reduction in compressive strength values of mortar mix with increasing marble powder content when compared with control sample at each curing age. No mortar cube with partial replacement of marble granules conform to the standard of IS:8112– 1989.

Experimental Study On Concrete Using Waste Marble

Experimental Study On Concrete Using Waste Marble

Oyedepo OJ, Oluwajana S, Akande SP. (2014). Investigation of Properties of Concrete Using Sawdust. as Partial Replacement for Sand. Civil and Environmental Research 6 (2):35-42. Pawar M, Dewangan A. (2014). The Significance of Partial Replacement of Cement With Waste Marble. Powder.Dec 01, 2012 Twelve mixes incorporating lime stone waste 25%, 50% and 75% replacement from sand with marble powder as additive by percent 5, 10, and 15% by cement weight. Phase II, the above experiment is repeated with the same components but with different content of cement.

Use of Waste Marble Powder as Partial Replacement in

Use of Waste Marble Powder as Partial Replacement in

of using marble powder waste as partial replacement of fine aggregate in concrete. Since this concrete is prepared with marble powder as a partial replacement of fine aggregate (Sand) in four different proportions i.e. 10%, 15 % ,20% and 25 % and tested for the period of …Omar et al [37] found that, the use of limestone waste as sand replacement and marble powder as an additive in concrete has more significant effect on the mechanical and permeability properties of ...

Experimental study of partial replacement of cement by

Experimental study of partial replacement of cement by

Hence result increased by the value of 9.2% and for 10% replacement with shows that marble powder when mixed with sand and cement sand the flexure strength also got increased about 9.3% but it together has low compressive strength as compared to the decreased when the mix contains 20% marble powder dust replacement of marble waste in cement and ...Partial Replacement of Cement With Marble Powder in Concrete. Concrete Mix Design The concrete used in this research work was made using Binder, Sand and Gravel. The concrete mix proportion was 124 by weight. Test specimens Test specimens consisting of 150150150 mm cubes for Compressive strength, 150mm dia,

Marble Powder As A Partial Replacement Of Sand - 1454

Marble Powder As A Partial Replacement Of Sand - 1454

Compressive Strength of Concrete by Using Lateritic Sand and Quarry Dust CEX042. Use of Industrial Waste Red Mud in the Production of Self Compacting Concrete CEX043. Experimental Investigation of Fibre reinforced Concrete ... Experimental Investigation of Marble Powder as a Partial Replacement …A substitute or replacement product for concrete industry needs to be found. The main parameter investigated in this study is M30 grade concrete with replacement of sand by granite powder by 0, 25 and 50% and cement was partial replacement with silica fume, fly ash, slag and super plasticizer.

Cement Replacement in concrete with Marble Dust

Cement Replacement in concrete with Marble Dust

marble dust powder on the concrete mix by partially replacing cement and sand with the marble powder dust. In this project, we check the effect on mechanical and physical properties of a concrete mix if varying marble powder dust is partially replaced in the concrete mix. 1.1 Research Significancegreen concrete containing quarry rock dust and marble sludge powder as fine aggregate” ARPN journal of engineering and applied sciences vol.4, june 2009. 8. Prof. Jayeshkumar Pitroda, Dr.L.B.ZALA, Dr.F.S.Umriagr (2012), “experimental investigations on partial replacement of cement with fly ash in design mix concrete”.

Experimental Study on Partial replacement of Sand with

Experimental Study on Partial replacement of Sand with

of concrete is increased by replacement of cement with marble dust powder up to 10%, and after than adding extra percentage of marble dust powder by replacement of cement, the compressive strength of concrete is start to decrease. According to this study, the replacement of cement up to 10% with marble dust powder in M-20 gradeBased on the data, a mix design for M30 grade concrete is made and the replacement of cement with marble powder by 0%, 5%, 10%, 15%, 20% and 25% is considered. The proportions of the basic constituents of concrete for all the six mix ratios are presented